Posted on 21st October 2026

Don’t Get Caught Out By The First Sharp Frost!

Is draining the sprayer tank enough to protect It from freezing?

In autumn, temperatures can quickly drop below freezing. That is why it is important to prepare sprayers for winter storage. If water remains in the system, the first freezing temperatures can cause damage that often goes unnoticed until spring. Read on to find out how to prepare your machine properly for winter so that it is ready for the next season.

Don’t get caught out by the first sharp frost!

When water freezes, its volume increases by approximately 9%. The resulting ice can damage pump housings, valves, filters and other system components.

  1. Thoroughly Flush the System and Clean the Exterior

After spraying, ensure that any remaining spray mixture is disposed of correctly in accordance with the plant protection product manufacturer’s instructions and applicable regulations.

Then thoroughly rinse the tank and the entire spraying system. If the machine is equipped with rotating tank-cleaning nozzles, use them. Circulate clean water through the relevant valves, pipes and nozzles to remove any remaining chemical residues.

Clean the exterior of the machine as well. A clean surface makes it easier to identify damage, worn components and signs of corrosion.

  1. Protect the Entire Spraying System Against Freezing

Draining the main tank alone does not protect the entire system.

Use a suitable antifreeze solution to protect to at least – 10 degrees.

Start the pump at low speed and gradually open each spray section individually until the antifreeze solution flows through every nozzle. This allows the protective fluid to reach the pump, pressure regulator and pipework, helping to prevent frost damage. In spring, the remaining solution can be drained into a suitable container and stored for reuse the following winter, provided that the product manufacturer’s instructions permit this.

  1. Clean the Nozzles and Filters

Remove the nozzle caps and any filters and carefully clean them with water and a soft brush.

Never use wire or other sharp metal objects to clean nozzle orifices. These can damage the precisely calibrated orifices, resulting in uneven spray distribution and incorrect application rates.

Also inspect the suction and pressure filters and clean thoroughly.

  1. Inspect the Pump and PTO Drive Shaft

Check the condition and level of the pump oil and carry out any necessary maintenance in accordance with the manufacturer’s instructions and the number of operating hours.

Clean and lubricate the designated lubrication points on the PTO drive shaft and check the condition of its protective guards.

  1. Protect the Pressure Gauge and Electronic Components

It is a good idea to remove the pressure gauge and store it upright in a warm place to prevent glycerine leakage and protect the measuring mechanism from any residual water that could freeze.

Whenever possible, store the machine in a dry, covered area throughout the winter.

Need Help Preparing Your Machine for Winter? Call us on 01507 466011

Looking for bespoke sprayers solutions & support?

We are independent crop sprayer specialists based in Alford, Lincolnshire. Established in 2006 our aim is to provide a wide range of services to the crop spraying industry.

Our Services → Get in touch →

© 2026 S&K Sprayer Services Ltd.  |  Privacy

Website by Yello Media